CNC Plasma Tables

Increase the capabilities of your CNC plasma table with our router attachment. With our adaptable mounting system and control software, you can attach standard router to your table. A 2.25 HP Porter Cable router, with custom control screen/profile mounting plate and clamps fully wired and ready to run. Other size routers are available.

Cut thicker plate on your plasma table with an Oxygen Acetylene Relay. This allows you to use an oxy torch for thicker plate. System comes with all software/custom macros and wiring. We do not provide solenoid, torch, or gas lines.

Hypertherm Plasma Torches have led the industry for quality and innovation. Hypertherm is the brand that so many manufacturers have learned to trust for a quality plasma torch.  We are official OEM suppliers for Hypertherm Plasma Torches.

System uses compressed air to raise and lower the water level.  More effective at reducing warpage and collecting smoke than standard water tray.  Easily change water level with a standard air compressor.  No pumps, water lines, or moving parts. Lower cost than competitors water try, which requires manually adding or removing water to adjust level. By far, a top seller among customers.

This system is comprised of a full metal skirt and bottom, below the cutting area. Customer must supply blower and duct work to evacuate fumes outside.  Your attached vacuum will pull the grit through. We can assist in sizing blower.

This system comprises cutting deck only. Any grit will fall straight through the slats an onto the floor. Good choice for the beginner who wants to get in a plasma table at the lowest cost.