Video Instructions

Plasma Table Instructional Videos

Setup & Machine Basics - These videos will walk you through the installation and set-up of your machine, as well as machine basics.


Setup & Machine Basics - Machines Purchased After April 1, 2017


Thank you for purchasing a plasma table from LDR Motion Systems. The chapters below will guide you from unpacking to setting up your table for your first cut. If something needs better explanation please contact us.

On that same note, we provide this installation manual as a tool to help and show what you can expect during set up of the machine. We ask that you proceed through all the steps before contacting us for further technical support.

BEFORE RECEIVING SHIPMENT

  • If any damage is observed you must make a note of it on the Bill of Lading BEFORE you sign for it.
  • Also have the truck driver sign next to your damage description.
  • If excessive damage is evident DO NOT SIGN THE BILL OF LADING.

A signed Bill of Lading is acknowledgement that the machine was delivered undamaged and makes insurance claims very difficult.

When lifting the machine from the front or rear you will need to use extended forks. If lifting from the right side, you will need to make sure forks do not extend so far as to damage the control box on the left side. Also, when lifting from the side you must place a cross bar on the forks so as to apply lifting pressure to machine frame and not the water table. Never lift on the gantry or the top rails.

  • Both sides of Gantry
  • Center Gantry
  • Cord for Control Box
  • Y Axis Cable Carrier
  • X Axis Cable Carrier
  • All Boxes











[/tab22]




Setup & Machine Basics - Machines Purchased Before April 1, 2017


Thank you for purchasing a plasma table from LDR Motion Systems. The chapters below will guide you from unpacking to setting up your table for your first cut. If something needs better explanation please contact us.

On that same note, we provide this installation manual as a tool to help and show what you can expect during set up of the machine. We ask that you proceed through all the steps before contacting us for further technical support.

BEFORE RECEIVING SHIPMENT

  • If any damage is observed you must make a note of it on the Bill of Lading BEFORE you sign for it.
  • Also have the truck driver sign next to your damage description.
  • If excessive damage is evident DO NOT SIGN THE BILL OF LADING.

A signed Bill of Lading is acknowledgement that the machine was delivered undamaged and makes insurance claims very difficult.

When lifting the machine from the front or rear you will need to use extended forks. If lifting from the right side, you will need to make sure forks do not extend so far as to damage the control box on the left side. Also, when lifting from the side you must place a cross bar on the forks so as to apply lifting pressure to machine frame and not the water table. Never lift on the gantry or the top rails.

  • Both sides of Gantry
  • Center Gantry
  • Cord for Control Box
  • Y Axis Cable Carrier
  • X Axis Cable Carrier
  • All Boxes

Remove the plastic covering control box being careful not to damage wires.